Correct installation of jaw crusher

Jaw crusher in addition to choose a high quality crusher, its assembly technology has also been a top priority Today a detailed introduce you how to install the jaw crusher:

1 Because of the large amount of jaw crusher vibration at work, so the machine should be installed in reinforced concrete structure, based on the basis of the weight of the desirable roughly is 8 to 10 times the weight of the machine, the depth of the foundation is greater than the depth of the land to freeze at that point, the size of the foundation drawing to provide to the relative position of host and anchor bolt of the motor and other related parameters, not as a working drawing Installation of anchor bolt must set aside the reserved hole, as the basis of the secondary grouting Blanking trough the height and size according to the lower part of the way of discharging is decided by the scene
2 In order to reduce the vibration and noise and its influence to the nearby buildings foundation, in the middle of the crusher and concrete foundation mat to hardwood pad, rubber belt, or other cushion damping materials, with secondary grouting cement firmly, then tighten the anchor bolts Liming heavy industry remind must use level in the process of the determination of the levelness of the machine, the deviation of levelness of wall in front of the frame under control in 2 mm width scope, rack levelness of inspection is particularly important, it can ensure the inlet position not crusher at work resulting from deviation occurs the phenomenon such as unilateral feed, to avoid damage to equipment due to uneven load
3 When installing the motor in addition to check the distance with the host, but should also check the motor pulley groove with the master parallel to the corresponding wheel center, to ensure that all of the v belt consistently work effectively
4 The discharging mouth size should be according to the required to adjust the product particle size To adjust, should be loosen tbolt and tighten the spring Using open roof bolt to adjust seat, insert or smoke to corresponding thickness of the gasket, then back up the roof bolt, adjust the moving jaw under the action of gravity, clung to rack ear seat, at the same time to press the gasket group gathering together Since then, adjust the spring pressure To ensure that the machine is working, the thrust plate and thrust plate mat clingy But shoulds not be too great pressure, as long as it doesn’t happen parts, finally lock adjustment

Product Categories : Jaw crusher Large jaw crusher